Objective

Test LED/GPIO, Check is it OK

Mode switch selection

Note

• Support up to 4 LEDs
• It is necessary to describe the GPIO and output level of LED in the configuration file
• LED will be ignore if commented

[LED_TEST]
	led_1_gpio = 4
	led_1_output_level = 1
	
	led_2_gpio = 10
	led_2_output_level = 1
	
	# led_3_gpio = 0
	# led_3_output_level = 1
	
	# led_4_gpio = 0
	# led_4_output_level = 1	

Operation steps

• Power on the BT Tester and select LED test function
• Connect the DUT and BT Tester，DUT control GPIO output high or low level
• DUT can not check is it success, need to observe the led manually
• DUT send response to Tester
• BT Tester will broadcast PASS voice message